Polaroid 636 restyle - Removing Film Door Assembly

15
Repair Manual Addendum Disassembly/Reassembly
17. Remove the film door assembly from the cone assembly as follows:
• Push out the non-gear side of the door hinge bracket (Figure 2-14) to release it from the
metal hanger.
• Lift off the film door assembly from the gear side of the metal hanger.
Figure 2-14. Removing film door assembly
Door Hinge Bracket
(Non-Gear Side)
Cone Assembly
Spread System and Film Door Assembly
Metal Hanger
Metal Hanger
Door Hinge Bracket
(Gear Side)
Spread System
Film Door
Plastic Bearing
Bearing Block
Frog's Tongue
Graphic Gripper