3
Repair Manual Addendum General Information
1. General Information
Background
This repair manual addendum covers the 636 restyle cameras. The restyle of the 636 camera
refreshes it appearance and makes it look more contemporary.
Note: This repair manual addendum describes the disassembly/reassembly procedures
that are different from those of the earlier 636 cameras. Information common to the
earlier 636 cameras are not included in this repair manual addendum. Refer to the 636
camera repair manual dated December 1995 for this common information.
To use this repair manual addendum effectively, one should be familiar with the
operation and disassembly/reassembly information in the 636 camera repair manual.
636 Restyle Functional/Aesthetic Changes
The 636 restyle cameras (Figure 1-1) are now being manufactured with functional/aesthetic
changes to the following camera parts:
• Lower Housing
• Upper/Lower Apron
• Close-up Lens Button/Close-up Lens
• Trim Actuator/Button Assembly
• Door
• Gripper
• Front Plate
• Hinge Support (Gear/Non-Gear Side)
• Pivot Pin (Gear/Non-Gear Side)
• Logo Label/Strip
• Strobe Cover
• Counter Window/Retainer
• Hand Strap, Front/Rear
• Eye Cup/Retainer
• Strap Strip
• Door Release Button
• S1/S10 Button
• S1/S10 Interlock
• Body
• Flash Tube Assembly (FTA)
• Meniscus Lens Bezel
To Next Page
Loading...
Need help?
General
