Polaroid 636 restyle - Releasing Lower Housing from Its Hinge Supports (Gear;Non-Gear Side); Removing Front Plate

7
Repair Manual Addendum Disassembly/Reassembly
3. While holding the 636 restyle camera in its picture taking position, push in both hinge
supports (gear/non-gear side) to release the lower housing (Figure 2-3).
Figure 2-3. Releasing lower housing from its hinge supports (gear/non-gear side)
Figure 2-4. Releasing lower housing from hinge supports (gear/non-gear side)
4. Using a dental pick or a small flat screwdriver, remove the front plate assembly as follows:
• Insert the tip of the dental pick or the small flat screwdriver between mating groove of the
front plate assembly and the upper apron assembly just above the negative lens at the
non-gear side of the front plate assembly (Figure 2-4).
Figure 2-4. Removing front plate
Lower Housing
Hinge Support
(Gear Side)
Strobe Cover
636 Restyle
Camera
Mating Groove
Front Plate
Negative Lens
Locking Tabs