Setting up 47
Use only the cable provided with the camera. Other cables
may appear similar, but could damage the camera or your
computer.
4 Connect the DB25/50 pin Centronics adapter (b) to the
connector from which you removed the terminator.
5 Connect the other end of the SCSI cable (d) to the SCSI
connector on the PDC-3000 camera.
6 Connect the camera to AC power using the power
adapter/trickle charger (e).
IMPORTANT: Always connect the camera to AC power
when it is connected to the computer. If the camera or any
other SCSI device turns off while connected, it could corrupt
data on your hard disk.
To Next Page
Loading...
