Using the PDC-3000 camera 96
4 To insert a new character at the cursor location, press the
Scroll button until the desired character appears in the space.
Press the Enter button to store the character and move the
cursor to the next space.
Note: Only upper case (capital) letters, numerals, hyphen (-)
and space are available for labels.
To leave a blank space, press the Enter button without
entering a character.
5 Repeat step 4 until you have completed the label (up to 10
characters and spaces).
6 Exit from the Label mode by pressing the Label button.
To individualize the default label for a single picture, use the
procedure in the following section.
To Next Page
Loading...
