Enable People Framing (Preview)
Enable People Framing (Preview) for your in Poly Lens Desktop.
Task
1 In Lens Desktop, select from the list in the left sidebar.
2 Select Controls.
3 From the Tracking Mode drop-down menu, select People Framing (Preview).
4 To give feedback, launch Poly Lens Desktop (1.1.19 or later), and select Feedback on the right sidebar.
Connect Poly Studio to a Bluetooth Device
Connect the Poly Studio device to a Bluetooth device and use it as the speaker and microphone of the Bluetooth device.
You can pair the Poly Studio device with a mobile phone, a computer or laptop, or a tablet.
Note: The Poly Studio device doesn’t support mixed types of audio and video input. If you connect it to a computer over
USB and Bluetooth at the same time, make sure that your application uses both audio and video input from the Poly Studio
device over USB.
Poly Studio only supports one Bluetooth connection at a time, but you can connect it to a computer over USB and to a
phone over Bluetooth.
Task
1 On the remote control, long press Bluetooth to enable the pairing mode.
The LED lights blink blue in the middle during the pairing process.
2 On your device, enable Bluetooth and select from the list of available devices.
The middle LED lights keep solid blue for three seconds with a notification sound.
You can start playing music or make phone calls from the Poly Studio speakerphone once you connect.
13
To Next Page
Loading...
Need help?
General
