Poly TC8 - Download Mibs

Setting Description
Location Name Specifies the system location.
System Description Provides details about the system.
User Name Specifies the User Security Model (USM) account name for
SNMPv3 message transactions. The maximum length is 64
characters.
Authentication Algorithm Specifies the type of SNMPv3 authentication algorithm used.
• SHA
• MD5
Authentication Password Specifies the SNMPv3 authentication password. The maximum
length is 48 characters.
Privacy Algorithm Specifies the cryptographic privacy algorithm for SNMPv3
packets.
• CFB-AES128
• CBC-DES
Privacy Password Specifies the SNMPv3 privacy (encryption) password. The
maximum length is 48 characters.
Engine ID Specifies the unique ID of the SNMPv3 engine. You might need
this information to match the configuration of an SNMP console
application. The ID is automatically generated, but you can
create your own as long as it is between 10 and 32 hexadecimal
digits. You can separate each group of two hex digits by a colon
(:) to form a full 8-bit value. A single hex digit delimited on each
side with a colon is equivalent to the same hex digit with a
leading zero (for example, :F: is equivalent to :0f:).
The ID can’t be all zeros or Fs.
Listening Port Specifies the port SNMP uses to listen for system messages (the
default is port 161).
Transport Protocol Specifies the transport protocol used.
• TCP
• UDP
Destination Address1
Destination Address2
Destination Address3
Specifies the IP addresses of SNMP managers where SNMP
traps are sent.
Each address has four settings:
• Server address (accepts IPv4 addresses, hostnames, and
FQDNs)
• Message type (Trap or Inform)
• Protocol (SNMP v1, v2c, or v3)
• Port where SNMP traps are sent (default is 162)
3 Select Save.
Download MIBs
You can download MIB data for your system.
126