Power
First time power
Your charge case is shipped from the factory in a Deepsleep mode to conserve the
battery.
On first use, wake your case by pressing the button on the back of the charge case or by
plugging into a power source using the provided charge cable.
Power on/off your earbud system
Your earbuds and case power on and off automatically.
To power on, do one of the following:
• Remove your earbuds from the case to automatically power them on. Conversely,
place your earbuds in the case to automatically power them off and start charging
them.
• To wake your case, tap the screen or press the button on the back of your case. The
charge case screen automatically times out when idle. Press the button on the back to
power off the screen and lock it.
• Tip: If you don't hear a voice alert when you put on your earbud, click the earbud
button once to power it on.
DeepSleep mode
If you leave your earbuds powered on but out of range of your paired device, they
conserve power by entering DeepSleep mode after 90 minutes.
To exit DeepSleep mode, power on by clicking each earbud button.
Wake your charge case
Wake your screen to use features or to view status. Your charge case touch screen times
out when idle for 15-45 seconds in most cases.
1 Wake your screen by doing one of the following:
• Tap the touch screen.
• Press the button on the back of the case.
• Open and close your charge case lid.
• Plug in to a power source or disconnect from it.
2 Power off your screen by doing one of the following:
13
To Next Page
Loading...
