Prerequisites
▪ Discover the camera IP address using the EagleEye Director II App.
▪ Use an Ethernet cable to connect the camera to your local computer.
Procedure
1. In the camera web interface, select Network Settings > WiFi and select Enable WiFi.
2. Enter the user name and password for authentication.
3. Use the EagleEye Director II App to discover the WiFi address for the new connection.
If the WiFi address is not found, WiFi authentication might have failed. Repeat the previous steps.
Related Links
View Device Status on page 12
Configure a Connection Mode
By selecting a mode in the web interface, you can set up an EagleEye Director II camera to work with a
RealPresence Group Series system, or to work with a local computer.
Procedure
1. Navigate to General Settings > Mode.
2. At Mode, select one of the following options.
Mode Options
Setting Description
Automatic Automatically detects a Group Series connection
or a Bring Your Own Device connection. If you
connect the camera to both a RealPresence Group
Series system (using HDCI) and a computer (using
USB), the camera does not work as expected.
Group Series Camera works with a RealPresence Group Series
system. If you connect your camera to a computer
in this mode, the computer does not detect the
camera as its USB camera.
Connect Your Own Device Camera works with a local computer so that you
can use the camera as a USB camera. This mode
is for computer connections only. If you connect the
camera to the RealPresence Group Series system
in this mode, the video conferencing system cannot
detect the camera.
3. Select Save.
Related Links
Cascading Two Cameras on page 21
Configure Settings in the App on page 13
Setting Up Connections
Polycom, Inc. 16
To Next Page
Loading...
