Polycom EagleEye Director II - Configuring Settings; Configure Camera Tracking

Configuring Settings
Topics:
▪ Configure Camera Tracking
▪ Configuring the PIP Layout
You can configure settings in the EagleEye Director II camera’s web interface for your environment.
Configure Camera Tracking
Tracking settings allow the camera to frame the speaker or the meeting participants, adjust the tracking
speed, and change the subject frame size.
Note: The following settings are also available in the RealPresence Group Series web interface. The
last changes to these settings are applied for the camera, whether you change the settings in the
RealPresence Group Series system settings, or in the EagleEye Director II settings.
Procedure
1. In the web interface, go to Camera Settings > Tracking.
2. Configure the following settings.
Setting Description
Tracking Mode ▪ Frame Speaker: Frames the active speaker.
▪ Frame Group: Frames the conference participants.
▪ Off: Disables automatic tracking and switches to manual mode. Note:
If setting is set to Off in the camera web interface, you cannot turn it
on from the RealPresence Group Series system’s local interface or
from the EagleEye Director II App.
Tracking
Speed
▪ Slow: Tracks transitions slowly.
▪ Medium: Tracks transitions at a medium rate.
▪ Fast: Tracks transitions quickly.
Framing Size ▪ Wide: Most expansive frame.
▪ Medium: Average-sized frame.
▪ Tight: Close-up frame.
Related Links
Configure Cascading on page 23
Polycom, Inc. 17