Polycom G7500 - Page 87

Specifies the port where SNMP traps are sent.
String (1-65535)
162 (default)
snmp.trapTarget.2.enable
Enable to send SNMP traps to an SNMP manager. You can send traps to up to three managers.
1 (default)
0
snmp.trapTarget.2.address
Specifies the IP address of an SNMP manager where SNMP traps are sent.
String (0-255)
snmp.trapTarget.2.messageType
Specifies the type of SNMP message.
Trap (default)
Inform
snmp.trapTarget.2.protocolVersion
Specifies the SNMP version used by the SNMP manager.
v3 (default)
v2c
v1
snmp.trapTarget.2.port
Specifies the port where SNMP traps are sent.
String (1-65535)
162 (default)
snmp.trapTarget.3.enable
Enable to send SNMP traps to an SNMP manager. You can send traps to up to three managers.
1 (default)
0
snmp.trapTarget.3.address
Specifies the IP address of an SNMP manager where SNMP traps are sent.
String (0-255)
snmp.trapTarget.3.messageType
Specifies the type of SNMP message.
Trap (default)
Inform
snmp.trapTarget.3.protocolVersion
Specifies the SNMP version used by the SNMP manager.
v3 (default)
SNMP Parameters
Polycom, Inc. 85