Release Notes
Polycom RealPresence Group Series, Version 4.1.1.1
Polycom, Inc. 27
Provisioning GS-11756 4.1.1 When the RealPresence Group
system is provisioned by the
RealPresence Resource
Manager system to use the
Maximum Security Profile, the
RealPresence Resource
Manager system does not apply
all the needed settings for the
Maximum Security Profile.
To use provisioning AND apply
the Maximum Security Profile to
the RealPresence Group
system endpoint, do the
following:
a) Do not allow provisioning to
take place in when you run the
setup wizard.
b) Finish the setup wizard
manually on the RealPresence
Group system endpoint,
selecting Maximum for the
Security Profile, loading all
necessary PKI certificates, and
adjusting the PKI settings as
desired.
c) After completing the setup
wizard, manually configure
provisioning and allow the
RealPresence Group system to
be provisioned, making certain
that the profile pushed to the
system has settings that are
consistent with Maximum
Security Profile. With version
4.1.0_J, the Security Profile
cannot be provisioned by the
RealPresence Resource
Manager system, so you must
set it prior to provisioning as
described above.
Manually configure the
endpoint to use the
Maximum Security Profile
prior to enabling
provisioning, as described
here.
Security GS-11970 4.1.1 When a RealPresence Group
system operates in the Low,
Medium, or High Security
Profile, the system allows
SNVPv3 passwords to be fewer
than eight characters. However,
regulations require that
SNMPv3 passwords be at least
eight characters long.
Specify eight or more
characters for the SNMP
Password.
Category Issue ID
Found in
Release Description Workaround
To Next Page
Loading...
Need help?
General
