Chapter 3 - System Commands
© Polycom, Inc. 3 - 85
sleeptext sleeptext <set|get> [“text”]
Where:
• set: Sets the text to be displayed on
the screen saver when followed by
the “text” parameter. To erase the
current setting, omit “text”.
• get: Returns the current text.
• “text”: Screen saver text to be
displayed when the VSX system is in
sleep mode. Enclose the text in
quotation marks if it includes
spaces.
Sets the text to be displayed on
the screen saver when the
system is in sleep mode.
sleeptext set
"Pick up the
remote control to
use the system"
sleeptime sleeptime
<0|1|3|15|30|60|120|240|480|get>
Where:
• 0, 1, 3, 15, 30, 60, 120, 240, 480:
Sets the number of minutes from last
user interaction to entering sleep
mode. The default value is 15.
• get: Returns the current value.
Sets the wait time value before
the VSX system goes to sleep
and displays the screen saver.
User interface screen location:
System > Admin Settings >
General Settings > System
Settings > Appearance:
Screen Saver Wait Time
sleeptime 1
stream stream <start|stop>
Where:
•start: Starts streaming. A meeting
password may be required.
•stop: Stops streaming.
Starts or stops streaming from
your system.
User interface screen location:
System > Utilities > Stream-
ing: Start Streaming
Note: This option is only visible
on the main user interface
screen if you have previously
enabled Allow Streaming.
stream start
streaman-
nounce
streamannounce <yes|no|get>
Where:
• yes: Enables streaming
announcement.
•no: Disables streaming
announcement.
•get: Returns the current setting (yes
or no).
Enables or disables streaming
announcement. When this
option is enabled, the names of
users logged on to your system
are displayed on screen.
User interface screen location:
System > Admin Settings >
Network > IP > Streaming:
Enable Streaming
Announcement
streamannounce
yes
streamau-
dioport
streamaudioport <set|get> ["stream
audio port"]
Where:
• set: Sets the stream audio port
when followed by the “stream audio
port” parameter. To erase the
current setting, omit the parameter.
•get: Returns the current setting.
• “stream audio port”: Audio port
number.
Sets or gets the stream audio
port. By default, the audio port is
a fixed port. This may be
changed if a user needs to go
through the firewall.
User interface screen location:
System > Admin Settings >
Network > IP > Streaming:
Audio Port
streamaudioport
set 16384
Command Syntax Description Example
To Next Page
Loading...
Need help?
General
