Chapter 3 - System Commands
© Polycom, Inc. 3 - 109
confirm-
dirdel
confirmdirdel <yes|no|get>
Where:
• yes: When deleting an entry from
the Directory (Address Book), the
user is prompted with “Are you sure
you want to delete this entry?”
•no: When deleting an entry from the
Directory (Address Book), the user
is no prompted with a message.
• get: Returns the current setting (yes
or no).
Confirms directory deletions.
User interface screen location:
System > Admin Settings >
General Settings > System
Settings > Directory: Confirm
Directory Deletions
confirmdirdel no
displayglo-
baladdresse
s
displayglobaladdresses
<yes|no|get>
Where:
•yes: Enables the display of global
addresses.
•no: Disables the display of global
addresses.
•get: Returns the current setting (yes
or no).
Enables/disables the display of
global addresses in the Global
Directory (GDS).
User interface screen location:
System > Admin Settings >
Global Services > Directory
Servers: Display Global
Addresses
displayglobal
addresses yes
encryption encryption <yes|no|get>
Where:
• yes: Enables encryption.
•no: Disables encryption.
• get: Returns the status of this option
(yes or no).
Sets the encryption mode.
User interface screen location:
System > Admin Settings >
Security > AES Encryption
Note: The Encryption options
are only visible on the user inter-
face if an encryption key has
been entered.
encryption yes
natconfig natconfig <auto|manual|off|get>
Where:
• auto: Specifies that the system is
behind a NAT; specifies that the
system will automatically discover
the public (WAN) address.
•manual: Specifies that the system is
behind a NAT. Requires the WAN
address to be assigned using the
wanipaddress command on
page 3-68.
• off: Disables the option.
•get: Returns the current setting.
Specifies how to configure the
NAT.
User interface screen location:
System > Admin Settings >
Network > IP > Firewall:
NAT Configuration
natconfig manual
Command Syntax Description Example
To Next Page
Loading...
Need help?
General
