9
TexJet® ECHO²
CAUTION:
Waste Tank Chip Level should always be more than 50%. If it gets
below 20%, a message that the “Maintenance cartridge is at the end
of its service life” will be displayed, and the Tank cannot be reset.
Replace the tank.
Cartridge Chip Reset
To check Cartridge chip level, tap on the drop icon on the top panel.
Reset procedure:
| 01_STEP
Press Start Position Button to send platen inside. Wait until the Ready
To Print message is displayed at the Platen Control panel.
| 03_STEP
Press on lower control panel Shift and then Reset Ink Cartridge Chips
(Down) button. Wait for cartridges to be marked with an X sign and then
turn grey.
| 05_STEP
Skip the Notice display screen by pressing, Proceed, Proceed and Yes
on the three displayed screens.
| 02_STEP
Open ink cartridge cover.
| 04_STEP
Close ink cartridge cover.
To Next Page
Loading...
