Polyprint S.A. Texjet+
Polyprint S.A – Texjet plus operation manual English V1.9
How to fill and refill the cartridges
Do not refill the cartridges while they are inserted into the printer. First
remove them from the printer and then proceed to the refilling procedure.
1. Use the 20ml syringe provided with the printer (the user can always use a syringe with a
different capacity as long as it has the same neck diameter that fits in the cartridge’s supply
hole). Remove the rubber seal from the cartridge’s supply hole:
80ml cartridges:
2. Place the cartridge so that the supply hole is facing up. This is done to avoid ink spilling
from the cartridge. Insert the syringe containing the ink and repeat to the point where the ink
has filled up about 90% of the cartridge:
To Next Page
Loading...
