Polyprint S.A. Texjet+
Polyprint S.A – Texjet plus operation manual English V1.9
Problem: Printhead clogging problems.
The capping station is dirty and either not cleaning the print head completely or adding
more debris to the print head and causing print head to become clogged.
Thoroughly clean the capping station. It can be cleaned with swabs and cleaner. Be sure to clean the
plastic around the foam pad as this is where the print head will rest when the printer is not in use.
Also be sure to clean the rubber wiper blades as these wipe excess ink and debris off the print head
and will accumulate said ink and debris.
Ink in the nozzle opening has dried out from exposure to air for an extended period.
Do head cleaning and printing nozzle checks until a decent nozzle check is achieved.
Perform a powerful cleaning circle and check if a decent nozzle check is achieved.
A serious or permanent clog of the head may require replacing the print head.
Please contact service personnel.
The print head was damaged by crashing into shirt plate, print plate or pre-treated shirt
etc.
Order replacement print head.
Please contact service personnel.
Prevention:
Perform the basic maintenance task according to the intervals given in the description
Run head cleanings before printing in the morning as well as printing a nozzle checks to gauge status
of print head prior to printing onto garments.
The pre-treated fabric must not touch the printer head, as the ink and pre-treatment will react upon
the head surface, potentially blocking nozzles. If this happens clean the Printhead immediately with
alcohol. In your daily operation of your printer, observe the correct procedures for the loading of
material onto your printer.
Problem: You decided to stop the print, but don’t know how.
Immediate to stop the printing.
Power OFF the printer
To chancel the printing.
Cancel the job and all other pending jobs from the Epson spooler in the windows control panel printer
and faxes. Check on the computer if the jobs are deleted. Restart the printer.
Problem: Load Paper. On the bottom display appears preparation error 0020.
The preparation to print couldn’t startup correctly.
It may appear to the printer after it has printed the white mask and before the CMYK layer.
The user only needs to press Shift+F1 to bypass it. The print job does not get lost and the
t-shirts are not damaged whatsoever. It has been noted that if the maintenance tank’s level
is below 50%, then the “load paper” message may appear more often. Make sure that the
maintenance tank is above 50%, otherwise reset it.
To Next Page
Loading...
