T-Top
Sunshades
1.
Start with the panel marked DRIVER FRONT.
Unlatch the driver’s side T-top, raise it halfway and
close the latch handle.
2.
With the top raised and resting on the center roof
rail, slide the flat edge
of
the sunshade panel (with
the
vinyl side
to
the
glass) between
the
glass and
plastic trim, making sure the edge marked DRIVER
FRONT is pointing to
the
front of
the
vehicle.
3.
Open
the
latch and close
the
T-top.
Check
to
see
if
there
are
any gaps showing. Unlatch the T-top and
adjust the sunshade as required.
stick
the VelcroB buttons on
the
glass for a proper fit
every time you install the sunshades. To do this, first
remove the T-top with the sunshade installed and
place
it
upside down on a table or bench. Take care
not to scratch the glass.
4.
Once the sunshade is installed properly, you can
2-67
To Next Page
Loading...
Need help?
General
