Setting the Tone
EQUALIZER:
A
seven
band equalizer is part
of
your
audio system. Slide the levers up to boost or down to
reduce frequency range.
Adjusting the Speakers
BAL:
Press this knob lightly
so
it extends. Turn it to
move the sound to the left or right speakers. The middle
position balances the sound between the speakers.
FADE:
Press this knob lightly
so
it extends. Turn it to
move the sound to the front or rear speakers. The middle
position balances the sound between the speakers.
hsh these knobs back into their stored positions when
you’re
not
using
them.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30
to
45
minutes long on each side. Tapes longer than
that
are
so
thin they may not work well in this player.
While the tape
is
playing, use the VOL, FADE and
BAL
controls just as you do for the radio. The display will
show
an
arrow to show which side of the tape is playing.
When the down indicator arrow is lit, selections listed
on the bottom side of the cassette are playing. When the
up arrow is lit, selections listed on the top side of the
cassette are playing. The tape player automatically
begins playing the other side when it reaches the end
of
the tape.
If
E
and a number appear on the radio display, the tape
won’t play because of an error.
0
0
E10:
The tape is tight and the player can’t turn the
tape hubs. Remove the tape. Hold the tape with the
open end down and try to turn the right hub to the
left with a pencil. Turn the tape over and repeat.
If the hubs do not turn easily, your tape may be
damaged and should not be used in the player.
Try a new tape to make sure your player is
working properly.
Ell:
The tape is broken. Try
a
new tape.
If
any error occurs repeatedly or if an error can’t be
corrected, please contact your dealer.
If
your radio
displays an error number, write
it
down and provide
it
to
your dealer when reporting the problem.
PREV
(1):
Press this button or the SEEK down arrow to
search for
the
previous selection on the tape. Your tape
must have at least three seconds of silence between each
selection for PREV or SEEK to work. The tape direction
arrow
blinks
during
PREV
or
SEEK operation. Press
PREV or the SEEK down arrow to stop searching. The
sound will mute during PREV or
SEEK
operation.
3-9
To Next Page
Loading...
Need help?
General
