NEXT
(2):
Press this button or the
SEEK
up arrow to
search for the next selection on the tape. If you hold the
button, the player will continue moving forward through
the
tape. Your tape must have at least three seconds
of
silence between each selection for NEXT or SEEK to
work. The tape direction arrow blinks during
NEXT
or
SEEK
operation. Press NEXT or the
SEEK
up
arrow
to
stop
searching. The sound will mute during
NEXT
or
SEEK
operation.
PROG
(3):
Press this button to play the other side
of the tape.
00
(4):
Press
this
button to reduce background
noise. Note that the double-D symbol will appear on
the display.
Dolby Noise Reduction
is
manufactured under a license
from
Dolby Laboratories Licensing Corporation. Dolby
and the double-D symbol are trademarks
of
Dolby
Laboratories Licensing Corporation.
REV
(5):
Press
this
button
to reverse the tape rapidly.
Press it again to return
to
playing speed. The radio will
play the last-selected station while the tape reverses.
You may select stations during
REV
operation by using
SEEK
or
TUNE.
FWD
(6):
Press
this
button to advance quickly to
another part of the tape. Press the button again to return
to playing speed. The radio
will
play the last-selected
station while the tape advances. You may select stations
during
FWD
operation by using SEEK or
TUNE.
AM-FM:
Press this button to play the radio when a tape
is
in
the player.
TAPEFLAY:
Press this button
to
change to the tape
function when the radio is
on.
The tape symbol with
an
arrow
will
appear
on
the display when the tape is active.
To return to playing the radio, press the
AM-FM
button.
E
JECE
Press
this
button to remove the tape. The radio
will play.
EJECT
may
be
activated with either the
ignition or radio
off.
Cassettes may be loaded with the
radio
off
if
this
button is pressed first.
CLN:
If this message appears on the display, the
cassette tape player needs to be cleaned. It will still play
tapes, but
you
should clean it as soon as possible to
prevent damage
to
the tapes and player.
See
“Care
of
Your
Cassette Tape Player”
in
the Index. After
you
clean
the player, press and hold EJECT for five seconds to
reset the CLN indicator. The radio will display
---
to
show the indicator was reset.
3-10
To Next Page
Loading...
