Theft-Deterrent Arming Verification
Your vehicle comes with this feature set in Mode
3.
To
change
the
factory setting, do the following:
1.
Press the LOCK button
on
the remote keyless
entry transmitter.
2. Count
the number of chimes you hear. The number of
chimes
tells
you which mode
your
vehicle is set for.
3.
Press the
LOCK
button on the remote keyless entry
transmitter until you hear the number of chimes that
corresponds to the
mode
selection you want.
Mode
1:
All
Off
(No
horn chrrps or parking lamp flash.)
Mode
2:
Horn and Lamps (Your parking lamps will
flash and your horn will chirp twice to verify the system
is armed using any arming method.)
Mode
3:
Horn and LampsLamps
(If
you use the remote
keyless entry transmitter to
arm
the system, your
parking lamps will flash and your horn will chup twice
to verify that the system is armed.
If
it only chqs once,
the
hatch
is
open
or
unlatched.
If you
use
either
the
power door lock switch or passive arming, only your
lamps will flash for verification.)
Mode
4:
Lamps (When your vehicle
arms,
only
your
parking lamps will flash for verification.)
Driver’s Door Alarm Delay and
Shock
Sensor Enable
Your vehicle comes with
this
feature set in Mode
4.
To
change the factory setting,
do
the following:
1.
Turn the parking lamps on and
off.
2.
Count the number
of
chimes you hear. The number of
chimes
tells
you which
mode
your
vehicle
is
set for.
3.
Turn the parking lamps on
and
off
until
you
hear the
number of chimes that corresponds to the mode
selection you want.
Mode
1:
Zero Delay and Shock Sensor Disabled (The
alarm
will sound immediately
if
the driver’s door is
opened with your key and the shock sensor will not be
available to measure sharp blows to your vehicle.)
Mode
2:
Eight-Second Delay and Shock Sensor
Disabled (The
alarm
will sound eight seconds after
the
driver’s door is opened with your key and the shock
sensor will not be available to measure sharp blows to
your vehicle.)
2-22
To Next Page
Loading...
