Pontiac 2003 Aztek - Removing the Floor Track Assembly

3. Disconnect the tethered Removing the Floor Track Assembly
ring from the hook and
place the tethered ring
on After the tray is removed, the floor track assembly also
the outer edge of the needs to be removed. Items should not be put onto
tailgate on each side of the floor track assembly.
the vehicle.
4. Push down on the release lever and roll the tray
into the vehicle approximately 6 inches (15.24 cm).
5. Use the handle to lift up on the tray while pulling it
towards you. Use your other hand to support and
lift the tray from the bottom. Remove the tray
from the vehicle.
TI-- “--r +hrr Cr-,, hnn w~ilnvc 4nw rnnrr;nm it nn thn
I I IG lcal VI 11 IC LIUY I IUJ IVII~IJ IVI I I IVVII 13 II VI I II ~b
ground, in an upright position, without having to carry it.
1. Feed the tethered rlng through the rear iower
sidewall loop on each side of the vehicle.
2. Unlock the slide locks from the two rear floor
retainers by pushing the button down and pressing
them inward.
3. Disengage the front forks from the retainers by
lifting and pulling the assembly toward you.
2-49