5.
6.
Press and hold the EQ button or push the SELECT
knob to store the equalization setting and the
number. You will hear a beep and EQ SAVED will
appear on the display.
Repeat the steps for the other EQ settings and
numbers.
EQ
5 has been programmed at the factory for use with
talk radio, but it can be preset
to
a different tone.
Adjusting the Speakers (Balance/Fade)
BAL
(Balance):
Press and release this button until
BAL appears on the display. The SELECT LED indicator
will light to show that the speakers can be adjusted.
Turn the SELECT knob to move
the
sound toward the
left or the right speakers.
FADE:
Press and release this button until FADE
appears on the display. The SELECT LED indicator will
light
to
show that the speakers can be adjusted.
Turn the SELECT knob to move the sound toward the
f:czt
c:
the
cnnsknrc
-r--*----.
Pressing and holding the BAL FADE button for two
seconds will return all speaker settings
to
the middle
position.
Finding a
PTY
Station
(RDS,
XMTM
and
DAB)
To select and find a desired PTY perform the following:
1.
Press PROG TYPE. The PTY symbol will be
2.
Select a category by turning the SELECT knob.
3.
Once the desired category is displayed, press either
displayed on the screen.
SEEK arrow
to
select the category and take you to
the category’s first station.
4. If you want
to
go
to
another station within that
category and the category is displayed, press
either SEEK arrow once. If the category is not
dispiayed,
press
either SEEK
arrow
twice
to
display
the category and then to go
to
another station.
5.
Press PROG TYPE to exit program type mode.
SCAN:
You
can also scan through the channels within
a category by performing the following:
1
Press
PROG
TYPE.
The PTY svmbol will be
2.
Select a category by turning the SELECT knob.
3.
Once the desired category is displayed, press and
hold either SCAN arrow, and the radio will begin
scanning within your chosen category.
particular station.
displayed on the screen.
4.
Press either SCAN arrow again
to
stop at a
3-67
To Next Page
Loading...
