5.
6.
7.
Unscrew the bulb socket from the lamp assembly
by pressing the tab while turning it
counterclockwise.
Replace the bulb by pulling the old one out and
gently pushing the new one into the lamp socket.
Line up the tabs on the socket with the gaps in the
socket holes and screw the bulb socket back into
the lamp housing until a click is heard (the tab
popping back out).
8.
To
reinstall the lamp assembly, align the tapered
pin on the bottom of the lamp with the plastic
socket on the fender bracket. Push down until the
pin snaps into the socket.
9.
Reinstall the two screws that were removed in
Step
2.
Taillamps, Stoplamps and Back-up
Lamps
1.
Open the liftgate and the tailgate.
2. Remove the two screws
from the taillamp
housing.
3.
Turn the lamp outboard, then pull the assembly
firmly rearward.
5-52
To Next Page
Loading...
