Unlock Feedback
The unlock feedback feature can be programmed
to
one
of the following modes:
LIGHTS:
This mode does the following:
During the day, when the ignition is in OFF and
UNLOCK on the remote keyless entry transmitter
is pressed, the headlamps and parking lamps
will flash.
During the night, when the ignition is in
OFF,
the
headlamps and parking lamps will be activated
for
30
seconds when UNLOCK is pressed on the
remote keyless entry transmitter. If you would like to
change the amount of time the lamps stay on,
change the headlamp exit delay feature.
OFF:
The headlamps and parking lamps will not flash
when UNLOCK is pressed on the remote keyless
entry transmitter.
Before your vehicle was shipped from the factory,
it
was
programmed in LIGHTS. The mode to which the
vehicle was programmed may have been changed since
it
left the factory.
To
determine the mode
to
which
your vehicle is programmed or
to
program your vehicle
to a different mode, do the following:
1.
2.
3.
4.
5.
Follow the instructions for “Entering Programming
Mode” listed previously.
Follow the instructions for programming HEADLAMP
EXIT DELAY earlier
in
this section,
to
make sure
which mode
it
is programmed
to.
Press the SET button until UNLOCK FEEDBACK
appears on the DIC.
Press the MODE button until the arrow is before
LIGHTS or OFF.
Press the SET button once you have determined
which mode you prefer.
The mode you selected
is
now set. You can either exit
programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
3-60
To Next Page
Loading...
