Lock Feedback
The lock feedback feature can be programmed
to
one
of the following modes:
OFF:
When LOCK is pressed on the remote keyless
entry transmitter, the headlamps and parking lamps will
not flash and the horn will not sound.
LIGHTS: When LOCK
is
pressed on the remote
keyless entry transmitter, the headlamps and parking
lamps will flash briefly.
HORN:
When LOCK is pressed on the remote keyless
entry transmitter, the headlamps and parking lamps
will flash briefly and the horn will sound.
Before your vehicle was shipped from the factory,
it
was
programmed in
HORN.
The mode
to
which the vehicle
was programmed may have been changed since it
left the factory.
To
determine the mode to which your
vehicle is programmed
or
to program your vehicle
to a different mode, do the tollowmg:
1.
Follow the instructions for "Entering Programming
2. Press the MODE button until LOCK FEEDBACK
3.
Press the
SET
button until the arrow is before
OFF,
Mode" listed previously.
appears on the DIC.
LIGHTS or
HORN.
The mode you selected is now set. You can either exit
programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
Exiting Programming
Mode
To exit programming mode, do one of the following:
shift out of PARK
(P),
turn the ignition key out of ON, or
do not program any commands for one minute
while in the programming mode.
The programming mode message will turn
off to let you
know
that
you are no longer in the programming
mode.
Once you have reached the end
of the personalization
features, PERSONALIZATION SELECTION
IS
DONE will appear briefly. Then PRESS §ET TO EXIT
MODE
TO
CONTINUE will appear. Pressing SET
will exit you out of the DIC. Pressing MODE will take
you to tne beginning
oi
personaiizaiiorl.
3-61
To Next Page
Loading...
