3.
4.
5.
Count the number of chimes you hear. The number
of chimes indicates the vehicle’s current
programmed mode.
If
you do not wish
to
change
the current mode, you can either exit the
programming mode by following the instructions
later in this section or program the next feature
available on your vehicle.
Press LOCK on the remote keyless entry transmitter
to
change the current mode.
Press LOCK on the remote keyless entry transmitter
until you hear the number of chimes corresponding
to
the mode selection you want.
The mode you selected is now set. You can either exit
the programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
Exiting
Programming
Mode
To exit programming mode, do one of the following:
Press the odometer button, while in odometer mode,
for two seconds, or
turn the ignition key out
of
ON,
or
*
do not program any commands for one minute
while in programming mode,
or
shift out of
PARK
(P).
See
Shifting
Out
of Park
(P)
on
page
2-33.
The programming mode message will turn off
to
let you
know that you are no longer in the programming mode.
2-59
To Next Page
Loading...
