Headlamp
Exit
Delay
This feature allows you
to
customize the headlamps and
parking lamps.
Programmable
Modes
Mode
1:
Off (The headlamps and parking lamps will
turn off at the same time that the ignition is turned
to
OFF.)
Mode
2:
15-Second Activation (The headlamps and
parking lamps will stay on for 15 seconds when
the ignition is turned to OFF.)
Mode
3:
30-Second Activation (The headlamps and
parking lamps will stay on for 30 seconds when
the ignition is turned to
OFF.)
Mode
4:
60-Second Activation (The headlamps and
parking lamps will stay on for
60
seconds when
the ignition is turned
to
OFF.)
3. Count the number of chimes you hear. The number
of chimes indicates the vehicle’s current
programmed mode. If you do
not
wish to change the
current mode, you can either exit the programming
mode by following the instructions later in this section
or program the next feature available on your vehicle.
4.
Turn the exterior lamp control from the off position
to the parking lamp position
to
change the
current mode.
5. Turn the exterior lamp control from the off position
to
the parking lamp position until you hear the
number of chimes corresponding
to
the mode
selection you want.
The mode you selected
is now set.
You
can either exit
programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
Before your vehicle was shipped from the factory, it was
programmed in Mode 3. The mode
to
which the
vehicle has been programmed may have been changed
since it left the factory. To determine the mode
to
which your vehicle is programmed or
to
program your
vehicle
to
a different mode, do the following:
1.
Follow the instructions for
Entering Programming
2. Turn the exterior lamp control from the
off
position
Mode
on
page
2-53.
to
the parking lamp position.
2-54
To Next Page
Loading...
