4. Peel the protective backing from the hook and loop
fastener and press it firmly to the back of your
garage door opener.
5. Line up the button on the garage door opener with
the opening in the storage compartment door. Make
sure the garage door opener button is facing
down and then press the opener firmly into the
garage door opener compartment.
6. Once the opener is installed, remove the three pegs
from the garage door opener button. Each peg is a
different size.
7. Put the garage door opener button back in by
inserting the tabs into the slot in the garage
door opener compartment.
8. Press the button on the garage door storage
compartment. If your garage door opener does not
work you will need to change the pegs until it does.
Storage Compartment
To open the storage compartment, located at the front
of the overhead console, press the release latch
forward. Then pull the compartment down to the full
open position.
Sunglasses Storage Compartment
To open the sunglasses storage compartment in the
overhead console, press the release button. Then pull
the compartment down to the full open position.
Front Door Utility Packs
Your vehicle may have front door utility packs. If it does,
the utility packs are located in the front door pockets
of your vehicle, and are used for extra storage space.
2-34
To Next Page
Loading...
Need help?
General
