OIL LIFE LEFT HOLD SET TO RESET: This message
displays the current percentage of the oil life by the
GM Oil Life System. To reset the oil life, press and hold
the SET button while this message is displayed.
When the system is reset 100% will be displayed and
the CHANGE ENGINE OIL message on the message
center will go off.
TIRE PRESSURE: The check tire pressure system can
alert you to a large change in the pressure of one
tire. You must begin driving before the system will detect
a low tire pressure.
USE SET TO SELECT ENGLISH METRIC: You can
use this display to select English or metric. Press
the SET button to toggle between English or metric.
The odometer, the trip odometer and if your vehicle is
equipped the head-up display will also change.
OFF: No driver information will be displayed in this
mode. If the DIC is left in this mode for more than
three seconds, the display will turn off. Press the
MODE button to start the DIC.
DIC Vehicle Personalization
The DIC is used to program the choices of two drivers.
The drivers are recognized as DRIVER 1 or DRIVER 2
on the DIC display. You will let the DIC know which
driver you are by using your remote keyless entry
transmitter. Each remote keyless entry transmitter was
pre-programmed to belong to DRIVER 1 or DRIVER 2.
Each transmitter may be programmed differently for
each driver’s preferences.
After you press the LOCK button on your transmitter
and the ignition key is in ON, the DIC will display
the identified driver number. The vehicle will also recall
the vehicle customization features that were last
programmed to correspond to your transmitter.
If you unlock your vehicle using your key instead of your
transmitter, the DIC will not change drivers and your
vehicle will recall the information from the last
transmitter used.
Entering Programming Mode
To program features, your vehicle must be in the
programming mode. Follow these steps:
1. Turn the ignition key to ON with the vehicle in
PARK (P).
2. Press and release the MODE button, scrolling
through the DIC messages, until PRESS SET
TO BEGIN PERSONALIZATION is displayed.
3-52
To Next Page
Loading...
Need help?
General
