Turn and Lane-Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return
automatically.
An arrow on the instrument
panel cluster and the HUD
display will flash in the
direction of the turn or lane
change.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by itself
when you release it.
As you signal a turn or a lane change, if the arrow
flashes faster than normal, a signal bulb may be burned
out and other drivers won’t see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when you signal
a turn, check for burned-out bulbs and check the
fuse. See
Fuses and Circuit Breakers on page 5-92
.
If you have a trailer towing option with added wiring for
the trailer lamps, the signal indicator will flash at a
normal rate even if a turn signal bulb is burned
out. Check the front and rear turn signal lamps regularly
to make sure they are working.
Turn Signal On Chime
If either turn signal is left on for more than 3/4 mile
(1.2 km), a chime will sound to let you know to turn it off.
To turn off the chime, turn off the signal.
Headlamp High/Low-Beam Changer
To change the headlamps from low to high, push the
turn signal lever away from you and release it. To
change the headlamps from high to low, pull the lever
toward you.
When the high beams are
on, this light, on the
instrument panel cluster
and the HUD display,
will also be on.
3-8
To Next Page
Loading...
Need help?
General
