ZONE # PRESS & HOLD SET TO CHANGE: This
display mode will be displayed when you are manually
calibrating the system. The current zone number for
compass variance will be displayed in place of the
# symbol. Use the SET button to select the zone number
from the graphic shown to select the current area of
the country that you are driving in.
PRESS SET TO CALIBRATE COMPASS: After
selecting your zone, press the MODE button and this
will be displayed on the DIC. Press the SET button and
complete three 360 degree turns in an area free from
large metal objects.
The following two messages will toggle in the display
until you calibrate the compass:
• DRIVE VEHICLE IN CIRCLE
• CALIBRATING COMPASS
When calibration is complete, the display will return to
its normal mode.
DIC Controls and Displays
When the ignition is turned to ON or START, the DIC
will display the following:
PONTIAC: PONTIAC will be displayed for
three seconds.
DRIVER #: This message will be displayed for three
seconds after PONTIAC appears in the display.
This message lets you know which remote keyless entry
and customization features the vehicle is using.
3-50
To Next Page
Loading...
Need help?
General
