Put back all tools as they were stored in the jack
storage compartment and put the compartment cover
back on.
To put the cover back on, slip the tabs on the bottom of
the cover into the bottom of the cover opening. Push
the cover in place and push down the tab on the top of
the cover so that it rests in the groove. This secures
the cover in place.
When you replace the compact spare with a full-size
tire, reinstall the bolt-on wheel covers or the center cap,
which ever your vehicle has. Tighten them “hand
tight” over the wheel nuts, using the folding wrench.
Storing the Flat Tire without the Sliding
Rear Convenience Tray
A. D-ring
B. Wing Nut
C. J-hook
D. Valve Stem
E. Full-size Tire
1. Flip up the D-ring located in the rear cargo area.
2. Lay the tire in the rear cargo area of the vehicle with
the valve stem up with the center hole of the tire
over the D-ring.
For vehicles with aluminum wheels, remove the
center cap by tapping the back of the cap with the
folding wrench.
5-80
To Next Page
Loading...
Need help?
General
