Posch SpaltFix S-360 User Manual

Notes on sawing
The drive must always be switched off before clearing a blockage.
Notes on splitting
Only use logs up to a diameter of 7 - 35 cm.
Logs must be pushed longitudinally towards the splitting blade.
▪ If necessary, correct the positioning and only then start the splitting process.
Remove jammed wood from the splitting blade with a striking tool.
Stop function
▪ If the safety guards are opened during work, the splitter will stop and the saw will return
to its home position.
– After closing the safety guards the splitting process will continue from where it was
interrupted.
Adjusting the log length
1
2
3
4
1 Fastening screw 3 Stop support
2 Stop 4 Threaded hole
The log length can be adjusted to 20, 25, 30, 33, 40, 45 or 50 cm using the stop.
1. Undo the fastening screw and remove the stop.
– On the stop support there are threaded holes for adjusting the cut length required.
2. Select the desired length and retighten the fastening screws.
6.1.1.1
6.1.1.2
6.1.2
6.1.3
Operation
21

Posch SpaltFix S-360 Specifications

General

Brand	Posch
Model	SpaltFix S-360
Category	Log Splitter
Language	English