Power Acoustik HD-14KIT - Page 11

Installation
6. If an alternative handlebar integration module is available, cut the wires leading to the 12-pin and 14-pin
connectors and discard them. Follow the color coded call-out below to connect the wires of HDHU.14+ wire
harness to the corresponding inputs and outputs of the alternate handlebar control module.
7. If an alternative handlebar integration module is available, cut the wires leading to the 12-pin and 14-pin
connectors and discard them. Follow the color coded call-out below to connect the wires of HD-14KIT wire
harness to the corresponding inputs and outputs of the alternate handlebar control module.
14-Pin Connector
12-Pin Connector
Red..........................ACC turn-on
Orange/White..........Illumination
Violet/White.............CAN -
Green/White............CAN +
Black.......................Ground
Yellow......................12V
Black/White..............Key/SWC Ground
Green/White.............Key/SWC 1
Grey/White...............Key/SWC 2
2
ROAD GLIDE STREET GLIDE
11