Power Electronics SD 300 Series - Page 27

POWER ELECTRONICS
SD300 – PROFINET
PARAMETERS CONFIGURATION
25
Code
Parameter Name
Value
Description
Frq / Speed
reference 1
0 Local
Select the frequency reference source for the
SD300 drive. Set the parameter to [8 COMMS]
to set PROFInet communication as the
frequency reference source.
OPT.
DESCR.
FUNCTION
0
LOCAL
Reference will be given by
keypad and will be set in dr.1.
2
V1
Reference will be introduced
through the voltage analog
input 1.
4
V2
Reference will be introduced
through the voltage analog
input 2.
5
I2
Reference will be introduced
through the current analog
input 2.
6
MODBUS
The reference will be
introduced through Modbus.
8
COMMS
The reference will be
introduced through the
communications.
9
PLC
The common area can be
linked with user sequence
output and can be used as
command.
12
PULSE
Reference will be introduced
through the Pulse input.
CM
06 FBus S/W Ver
-
Automatically detects and displays the software
version of the currently installed communication
module.
09 FBus Led
-
Displays the communication module status
indicator (LED) information on the drive keypad.
For more information, refer to “Part Names and
Installation”.
Example of “[CM 09] FBus Led” status displayed
on the keypad:
Indicator
Name
LINK1/
ACT1
LINK2/
ACT2
ERR
CPU
Status
OFF
ON
ON
ON