VS65
POWER ELECTRONICS
8
SAFETY INSTRUCTIONS
WARNINGS
RECEPTION
The VS65 softstarters are carefully tested and perfectly packed before leaving
the factory.
In the even of transport damage, please ensure that you notify the transport
agency and POWER ELECTRONICS: 902 40 20 70 (International +34 96 136
65 57) or your nearest agent, within 24hrs from receipt of the goods.
UNPACKING
Make sure model and serial number of the variable speed drive are the same
on the box, delivery note and unit.
Each softstarter is supplied with a technical manual.
RECYCLING
Packing of the equipments should be recycled. For this, it is necessary to
separate different materials included (plastic, paper, cardboard, wood, ...) and
deposit them on proper banks.
Waste products of electric and electronic devices should be selectively
collected for their correct environmental management.
SAFETY
Before operating the softstarter, read this manual thoroughly to gain and
understanding of the unit. If any doubt exists then please contact POWER
ELECTRONICS, (902 40 20 70 / +34 96 136 65 57) or your nearest agent.
Wear safety glasses when operating the equipment with power applied and the
front cover is removed.
Handle the softstarter with care according to its weight.
Do not place heavy objects on the softstarter.
Ensure that the mounting orientation is correct.
Do not drop the softstarter or subject it to impact.
The VS65 softstarters contain static sensitive printed circuits boards. Use static
safety procedures when handling these boards.
Avoid installing the softstarter in conditions that differ from those described in
the Technical Characteristics section.
To Next Page
Loading...
Need help?
General
