POWER ELECTRONICS
VS65
FAULT MESSAGES. DESCRIPTIONS AND ACTIONS
33
6.2. Fault History
The soft starter can save up to 5 faults history for analysis in future.
6.2.1. Display the saved fault
When the starter is in the ready status (or fault status), press “PRGM” for more than 4 seconds.
The No.1 fault is the latest fault and the new faults will overwrite the previous ones.
Press the ”∧” key to view the previous fault.
Figure 6.2 Saved Fault
6.2.2. Fault clearance
After all faults are reviewed, it is recommended to erase all fault history. To do this, press “PRGM”
for more than 4 seconds when viewing the saved faults.
To Next Page
Loading...
