Powermate L1 series - Section C; Bottom Guard Replacement

Page 6 of 19
PowerMate
®
L1/L2 Series Model
Repair Manual
BOTTOM GUARD REPLACEMENT
Replacement Kit No. 410060
PROCEDURE:
Tools required: Two 1/4"drifts, screwdrivers(phillips), or pry type tools.
-used to pull and align holes in rubber to holes in toeplate.
- 7/16"socket wrench.
- Two 2" C-clamps.
1. Extend PowerMate unit approximately 15"and rest the unit face down(wheels up)
on a suitable work surface. The floor may also be used. Note: The view above is
shown as the toeplate only for clarity.
2. Remove the 1/4"Nuts with the 7/16"wrench and dis-assemble the old Rubber Guard.
3. Use the screw driver type tools to align the holes of the new Rubber Guard and the Toeplate.
4. Apply the two 2"C-Clamps either side of the center hole leaving room to apply a Washer.
5. Insert a Carriage Bolt and Washer through the center hole as shown, and place a Washer
on the exposed thread. Applying thumb pressure to the head of the Bolt, start the 1/4"Nut
onto the thread. Remove the C-Clamps and tighten the 1/4"Nut with the 7/16"wrench.
6. Re-install the C-Clamps adjacent to another hole, remove the alignment device, and repeat
the Bolt installation step 5.
(6) 1/4-20NC x 7/8"Carraige Bolt
(12) 1/4"Plate Washer
(2) Rubber Guard
(6) 1/4-20NC Nut
(2) 2"C-Clamp
1/4"Alignment Device
-Phillips Screw Driver shown.
-2 required.
Section C: Bottom Guard Replacement