powersoft T Series - Page 68

INDEX
68
T-SERIES | SERVICE MANUAL
21. Location to Paste the Anti-Tamper Label after Repaired.
For every In-Warranty repair, you have to paste the Anti-Tamper
Label on the instructed position.
Upon receiving the Faulty Unit, inspect the Label to see if there’s
any Tampering. IF found any sign of damage to the Label, Amplier
will consider Out-Of-Warranty.
22. Location to Paste the ASC Replacement Mark after Repaired
This label is mandatory to apply to the board that has been repaired with replacing one component or Kit of components!
The label must be applied on top side of the pcb of the repair board wherever there is a little space available.
DO NOT paste it on the removeable parts like heatsink, capacitors, transformers, etc…