PowerSync LFP-LV - Safety Check; UL-1973 Certification

1. 9. SAFETY CHECK
Afterremovingthebatterymodulefromthebox,inspecteachbatterymoduletoensurethatthereisno
damage.
ThePOWERSYNCbatterymodulesaresuppliedwithamainpowerswitchonthefrontofthebattery.
Master Switch
EnsurethattheMainSwitchonthefrontofthebatterymoduleisintheoffposition.Removetheterminalcaps.
Usingamultimeter,testtheterminals.Thevoltageshouldreadzero“0V”.
TurntheMainSwitchtothe“ON”position.Usingamultimeter,testtheterminals.Thevoltageshouldreada
voltageofgreaterthan10V.
TurntheMainSwitchtothe“OFF”position.Usingamultimeter,testtheterminalstoensurethatthevoltageis
onceagainreadingzero“0V”.
PERFORM ALL INSTALLATION AND MAINTENANCE AND CABLE CONNECTIONS WITH THE MAIN SWITCH IN THE “OFF”
POSITION.
1. 10. UL-1973 CERTIFICATION
TheIntertekETL(UL-1973)certicationstickerislocatedonthelateralsideoftheLFP-LVModule.Thelistingcan
befoundontheIntertekDirectoryofListedProductswebsite.
CAUTION
* For long term storage,the battery state f charge should be kept at
+/-40%
* A regular charge a nd discharg
g
e cycle should be performed
approximately once every 3 months
* Do not s hort-circuit, over-char e,or over discharge the battery
* Do n ot disassemble or modify the battery
* Do n ot e xpose the battery to heat,flame,water
* Do n ot reverse the polarity of the battery
CERTIFIED TO ANSI/CAN/UL STD.1973
58.4V
o
www.powersyncenergy.com
(877)459-4591
©2022POWERSYNCEnergySolutions,LLC
8
01/10/23
LFP-LV Module Product Manual