WARNING AND SAFETY NOTES
• Please bear in mind the following points before commencing charging:
Did you select the appropriate program suitable for the type of battery
you are charging?
Did you setup adequate currentfor charging or discharging?
Have you checked the battery voltage? Lithium battery packs can be
wired in parallel and in series, i.e. a 2cell pack canbe 3.7V (in parallel)
or 7.4V (in series).
Have you checked that all connections are firm and secure? Make
sure there are no intermittent contacts at any point in the circuit.
• Charging
During charge process, a specific quantity of electrical energy is fed into the battery. The
charge quantity is calculated by multiplying charge current by charge time. The maximum
permissible charge current varies depending on the battery type or its performance, and can
be found in the information by the battery manufacturer. Only batteries that are expressly
stated to be capable of quick-charge are allowed to be charged at rates higher than the
standard charge current.
Connect the battery to the terminal of the charger: red is positive and black is negative. Due to
the difference between resistance of cable and connector, the charger can not detect
resistance of the battery pack, the essential requirement for the charger to work properly is
that the charge lead should be of adequate conductor cross-section, and high quality
connectors which are normally gold-plated should be fitted to both ends
To Next Page
Loading...
