PowerTech MP3741 User Manual

Page 16
3.3 Parameter setting
Load mode setting (Load means switched power output terminals)
Set Load modes as follows as below
Operating Steps:
Under load mode setting interface, press ENTER button and hold for 5
seconds till the number begin flashing, then press SELECT button to select
the parameter, press ENTER button to confirm.
Time 1
Time 2
Light ON/OFF
Disabled
Load will be on for 1 hour
Load will be on for 1 hour
since sunset
before sunrise
Load will be on for 2 hours
Load will be on for 2 hours
since sunset
before sunrise
～
Load will be on for 3～13 hours
～
Load will be on for 3～13
since sunset
hours before sunrise
Load will be on for 14 hours
Load will be on for 14
since sunset
hours before sunrise
Load will be on for 15 hours
Load will be on for 15
since sunset
hours before sunrise
Test mode
Disabled
Manual mode(Default load
Disabled
ON)
NOTE: Please set Light ON/OFF, Test mode and Manual mode via Timer 1.
Timer 2 will be disabled and display " ".

PowerTech MP3741 Specifications

General

Brand	PowerTech
Model	MP3741
Category	Controller
Language	English