Specifications
29
Powerware
®
5105 User’s Guide S 05146193 A Uncontrolled Copy
Table 6. Environmental and Safety
120V Models 230V Models
Operating Temperature 0°C to 40°C (32°F to 104°F); UL tested 25°C (77°F)
Storage Temperature -20°C to 60°C (-4°F to 140°F)
Relative Humidity 5–95% noncondensing
Operating Altitude Up to 3,000 meters above sea level
Audible Noise Less than 45 dBA typical
Surge Suppression ANSI C62.41 Category B (fomerly IEEE 587)
Safety Conformance UL 1778; UL 497A;
CAN/CSA C22.2, No. 107.1
UL 1778; UL 497A (data line only);
CAN/CSA C22.2, No. 107.1;
EN 50091-1-1 and IEC 60950
Agency Markings UL, CSA UL and CSA (except 1500VA); CE, VDE,
NEMKO, FIMKO, DEMKO, SEMKO
EMC FCC Part 15, ICES-003 EN 50091-2, FCC Part 15, ICES-003
Table 7. Indicators and Controls
Serial Communication Intelligent serial communication to provide alarms with history, measured parameters,
self-test, and many other features; contact your authorized dealer for UPS/computer
communication software options
Interface Ergonomic Indicators: Site Wiring Fault, Battery Service, Communication, Operation, System
Normal
Bar Graphs: Input Level, Battery Charge Level, Load Level
Contact Closures AC Input Failure, Low Battery
Table 8. Battery
Configuration 450 VA: (1) 12V, 7 Ah internal battery
700 VA: (1) 12V, 11 Ah internal battery
1000 VA: (4) 6V, 12 Ah internal batteries
1500 VA: (2) 12V, 17 Ah internal batteries
Voltage 450–700 VA: 12 Vdc
1000–1500 VA: 24 Vdc
Type Sealed, maintenance-free, valve-regulated, lead-acid
Charging Advanced charging for faster recovery; approximately 4 hours to 90% usable capacity at
nominal line and no supplementary power supply load
Monitoring Advanced monitoring for earlier failure detection and warning
To Next Page
Loading...
