PR8000 9mt 4x2000W METAL HALIDE
01-04-2011
12.10 REMARKS
It is important that the operator is always careful of potential breakdowns.
It is required that the lighting tower is operated by authorised and trained personel only.
It is recommended that a visual check is performed regularly before operating the lighting tower.
The authorised operator must not allow anyone to stand close to the lighting tower, when it is in
operation.
Always leave a clear space around the lighting tower.
It is recommended positioning the lighting tower on level stable ground. Refer to the spirit level
placed on the frame (Fig. 1).
(Fig. 1)
It is also recommended to position the lighting tower on a level stable surface, to allow
secure support for the stabilisers.
Pull the hand brake if the tower is not secured for towing on a truck/vehicle.
Authorised, trained personel are the only staff allowed to operate the lighting tower.
Before operating lighting tower it is recommended the authorised staff read and understand
all warnings and dangers described in this manual.
PR POWER is not responsible of any damage to equipment or persons, as a consequence of not
adhering to the safety guidelines.
For the electrical connection between the floodlights and the control panel of the lighting tower, it
has been used a turn cable 11G2,5 mmq placed to the inside of cylinder that allows for comfortable
sliding.
The coil cable needs to be inspected to ensure that high temperatures have not affected the
integrity of the coil.
To Next Page
Loading...
