2.
Ensure the two RCD's are in the OFF or TRIPPED position.
Stabiliser Leg Control Levers, located on the Control Panel.
The mast must be fully retracted to operated to operate the hydraulic
stabiliser legs.
To raise or lower all four hydraulic stabiliser legs, operate the
HYDRAULIC STABILISER LEG OPERATION
Turn off engine ignition.
Turn off the two RCD's.
Allow the engine to cool down.
Turn off ALL lamp circuit breakers.
SWITCHING OFF LAMPS
LAMP OPERATION
Switch the two RCD's to the ON position.
Switch on the first lamp circuit breakers and allow it to warm up.
Switch on the remaining lamp circuit breakers, allowing each one
to warm up, before operating the next.
To tilt the lamps operate the Light Inclination Lever, located on
the Control Panel.
on the Control Panel.
Engage the locking pin to secure the mast into position.
To raise or lower mast, operate the Mast Control Lever, located
manually, to the desired position.
To rotate the mast, disengage the locking pin and rotate the mast
(located at the base of the mast) engaged, before operating the mast.
ALL stabiliser legs must be lowered and in position and the locking pin
MAST OPERATION
Allow engine to reach correct operating temperature, before continuing.
iii. Turn ignition to the ST position to start.
ii. Turn ignition to the GL position and wait 10 seconds.
i. Turn ignition to the ON position.
To start the engine:
Ensure ALL lamp circuit breakers are in the OFF position.
1.
4.
3.
2.
1.
4.
3.
2.
4.
3.
2.
1.
2.
1.
5.
4.
3.
BEFORE STARTING THE ENGINE
Check engine oil, coolant and fuel levels (top up as required).
other hazards/obstructions.
Ensure handbrake on drawbar is locked in position.
Ensure the lighting tower is positioned away from powerlines and
Ensure ALL four stabiliser legs are fully deployed and in position.
Check the spirit levels (located on top of the canopy) for correct levels.
Ensure the lighting tower is positioned on level ground.
Read the PR8000 Operating Manual, before operating the equipment.
PRE-START CHECK
PR8000 OPERATION INSTRUCTIONS
4.
1.
6.
5.
2.
3.
1.
To Next Page
Loading...
