Functional characteristics
MIG/MAG welding
38 Item No.: 099-004838-PRA01
5.2.4 MIG/MAG automatic cut-out
If pressing the torch trigger does not ignite the arc or if the arc is interrupted by the torch being
removed during the welding process, automatic cut-out occurs within 5 seconds. The welding
machine ends the welding process immediately (open circuit voltage or welding current, wire
feed and shielding gas are shut off).
5.2.5 Standard MIG/MAG torch
The torch button on the MIG welding torch is normally used for starting and stopping the welding process.
Several additional functions are possible using the Powercontrol, RETOX or Up/Down torch.
Operating elements Functions
1 torch trigger Welding On/Off
Special latched: "tapping" (press briefly and release) can be used to
switch between the main program P
A
and reduced main program P
B
.
To Next Page
Loading...
