page 10
Diagram 2
Hardware kit.
AC
D
B
Carefully unpack the pieces of the treadmill and lay them on the floor near the
location where you plan to use the treadmill.
Hardware Kit
After unpacking the treadmill, open the hardware kit (refer to Diagram 2) and make
sure that you have the following items:
(A) four 2-inch socket head screws — used to mount upright supports to base
(B) four barrel spacers — place on 2-inch screws
(C) sixteen ¾-inch socket head screws
(D) twenty-two flat washers
(E) two large diameter washers — place on handrail side bracket screws
(F) two 1½-inch socket head screws — used on upper handrail clamp
(G) ¼-inch hex key — 3 inch by 10 inch
If any items are missing, contact Customer Support at 1-800-347-4404.
Note: After assembling the treadmill, be sure to store the hex key in a secure place.
It is used for specific maintenance procedures that are described in this manual.
Acquiring the Appropriate Tools
Obtain the following tools
before
assembling the treadmill.
Wire cutter
½-inch box end wrench
Bubble level
E
F
G
To Next Page
Loading...
