page 28
When you first turn the unit ON, the Precor banner “PRECOR WORK OUT
SMARTER” appears in the center display window. This banner indicates that the
M9.33 is ready to accept user entries.
Keypad Tips
Important: The keys on the keypad are touch-sensitive. A light “touch” is all that
is required to activate the key function.
• Accurate entries are required or features such as Smart Rate will not work properly.
• During the Setup prompts, you can change the information being displayed by
pressing any ▼ or ▲ key. (Incline and speed levels are not affected until the course
begins.)
• Press Enter to select the information being displayed.
• Pressing Quick Start at the Precor banner bypasses further selections and
displays the Manual course. Default values apply. The Smart Rate
®
display does
not appear. Refer to
The Setup Mode and the Quick Start Feature
on page 23.
• A time-out occurs during the Setup prompts if the M9.33 detects no key presses
for two minutes. The display returns to the Precor banner.
• Press Reset to return to the Precor banner.
Special Keypad Functions at the Precor Banner
You can perform a variety of tasks from the banner using different key presses:
Note: Key presses to the ▼ or ▲ key are ignored when the banner is being displayed.
1 key — selects User 1. The last course accessed by User 1, along with the workout
time, weight, and age is retrieved from memory.
RESET — initiates the diagnostic mode. Refer to
Advanced Techniques for the M9.33
on page 35.
QUICK START — causes the system to start the Manual course. Default settings
apply. Refer to
The Setup Mode and the Quick Start Feature
on page 26. No informa-
tion stored with either User I.D. is changed.
ENTER — initiates the Setup mode and causes the User I.D. prompt to appear.
2 key — selects User 2. The last course accessed by User 2, along with his or her
workout time, weight, and age is retrieved from memory.
Keys on the Keypad
The following information explains the different uses of the keys from left to right. To
locate each key, look at the display console or refer to Diagram 17.
INCLINE
▲▼▲▼
▲▼▲▼
▲▼: During a workout, the Incline
▲▼▲▼
▲▼▲▼
▲▼ keys let you increase or decrease
the incline. The display can show a range from 0 to 15. Setting 0 is the level (and
lowest) incline.
When you change the incline by pressing the Incline
▲ ▲
▲ ▲
▲ or
▼▼
▼▼
▼ key, the number that
appears on the display shows the
target
incline (not necessarily, the present incline)
because the display can change much faster than the treadmill’s lift.
Note: Any time during your workout, you can view the actual incline by lightly
touching either Incline
▲ ▲
▲ ▲
▲ or
▼▼
▼▼
▼ key. You can opt to change the incline, if you hold the
key down for more than one second.
5
The M9.33 Keypad
To Next Page
Loading...
