page 31
Several aspects of the M9.33 can be programmed. This section provides instructions
on how to:
• select U.S. standard or Metric display
• enable or disable password protection
• view the odometer, hours of use, software version, and error log
Programming Tips
Certain aspects of the M9.33 are hidden and can only be accessed using special key
presses. To avoid unauthorized use, certain rules apply. Tips to consider while
programming or viewing diagnostic information are shown below:
• Always start at the Precor banner.
• The advanced programming and diagnostic mode is accessed by pressing the
Reset key while the Precor banner is displayed. A second key press must occur
within 1/3 second after pressing Reset or the display returns to the Precor banner.
The third and subsequent key presses must occur within four seconds of the
previous key press or the Precor banner returns and you will need to begin again.
• The Select and ▼▲ keys let you preview information pertinent to the program.
• Exit the programming or diagnostic mode by pressing Reset. Note that the display
remains blank for one second and any additional key presses are ignored.
Selecting a U.S. Standard or Metric Display
The M9.33 can display units of measure in either U.S. Standard or Metric. When the
treadmill is shipped from the factory it is set to display U.S. Standard units of mea-
sure. You can easily change this setting by taking the following steps:
1. Check that the M9.33 is ON. If necessary, turn ON the treadmill using the power
switch located at the front of the unit.
2. At the Precor banner, press the following keys in sequence:
Reset, Quick Start, Enter, Select [2], Incline ▲
The numbers 5, 6, 7, 1 appear on the display as you press the associated key.
Important: If the second key press (Quick Start) is not pressed within
1/3 second after pressing Reset, the display returns to the Precor banner. You
will need to begin again.
3. The prompt, “Select Units” appears on the display and then, the current unit of
measure appears. Any ▼ or ▲ key lets you alternate between the prompts.
Important: If you change the units of measure, previously recorded rest and work
speeds in the Interval or Custom courses are cleared and reset to 1 mph (1.5 kph).
4. Once your selection is displayed, three options exist. You can,
a. press Enter to accept the unit of measure being displayed and continue with
programming the treadmill. The changes are saved in memory. The M9.33
will retain your selection even when it is turned OFF and unplugged.
b. press the red Stop button which keeps the “current unit of measure” unchanged
and advances to the next program.
Note: The “current unit of measure” is not necessarily the one being
displayed. It refers to the unit of measure that was in existence prior to
entering the “Select Units” program.
c. press Reset which keeps the “current unit of measure” unchanged, ends the
programming mode, and returns to the Precor banner.
6
Advanced Programming Techniques
To Next Page
Loading...
